Databridge Installation Guide > Getting Started > Start and Stop the Client Manager > Start the Service (Windows)

Start the Service (Windows)

If you installed the Client Console and checked the “Start Client Manager Service" checkbox, the Client Manager will open on its own. If not, use the following procedure to start the service in Windows.

To Start the Client Manager

  1. From the Start menu, open your Control Panel, click Administrative Tools, then double-click Services.

  2. In the Services window, find and double-click Databridge Client Manager 6.6 in the list.

    Databridge Client Manager 6.6 Properties dialog box opens.

  3. (Optional) On the Recovery tab of the dialog box, specify that the service is restarted after the first or second failures and click <Apply> to save your settings.

    NOTE:Do not set more than two failures; if the service fails more than that, a service failure is important to inform you of the problem.)

  4. Click the <Start> button under “Service status”.

  5. Click <OK> to save and close the Properties dialog box.

  6. Launch the Client Console and follow the instructions to add the service. See Start the Client Console (Windows).